Crestron

Activates the Modular Programming Architecture feature of the RMC3 3-Series Room Media Controller. Enables support for running up to 10 simultaneous programs on a single RMC3.

The C2N-IRGW-1G IR Gateway is a 1-way infrared receiver for Crestron iR wireless handheld remotes and touch panels. It is also compatible with third-party IR remotes utilizing the RC5 command set.

The CNPI-16B allows third-party custom control panels to be interfaced to the Cresnet system in the same manner as a Crestron keypad. Sixteen digital inputs accept contact closures from third-party switches, and sixteen output drivers are provided to accommodate incandescent lamps or LEDs.

The CNRFGWA Gateway is an RF receiver that allows Crestron433 MHz 1-way RF wireless touch panels and handheld remotes to communicate with the control system via the Cresnet network. Each CNRFGWA affords a range of approximately 300 feet. extended range can be achieved by distributing multiple gateways throughout a structure. Each gateway behaves as a Cresnet slave device requiring just one Cresnet wire to each gateway location.[1]

The CNRFGWA-418 Gateway is an RF receiver that allows Crestron418 MHz 1-way RF wireless touch panels and handheld remotes to communicate with the control system via the Cresnet network. Each CNRFGWA-418 affords a range of approximately 300 feet. extended range can be achieved by distributing multiple gateways throughout a structure. Each gateway behaves as a Cresnet slave device requiring just one Cresnet wire to each gateway location.[1]

The CSP-LSP is an accessory designed to protect a Crestron control system from lightning surges and other electrical disturbances brought through the Cresnet control line. Four-stage lightning suppression provides superior protection against damage to the control system caused by lightning strikes to remote Cresnet devices and wiring, especially outdoor equipment and underground cabling. It is also effective for protection against transients picked up by indoor networks in any facility that is...

The CSP-RS232I is an accessory designed to protect a Crestron control system's COM ports from lightning surges and other electrical disturbances brought through the RS-232 control line [1]. By electrically isolating any distant, outdoor device such as a pool & spa controller or irrigation system, the CSP-RS232I can prevent damage to the control system in the event of a near lightning strike, ground-loop, or short from a high voltage line.

Every installer knows running wires is a challenge and it adds substantial cost to any project. Crestron infiNET EX technology offers a wireless solution for controlling many devices in a home or commercial facility, eliminating the need to cut into walls, fish through insulation, or install extensive conduit just to get a wire to each device.

Every installer knows running wires is a challenge and it adds substantial cost to any project. Crestron infiNET EX technology offers a wireless solution for controlling many devices in a home or commercial facility, eliminating the need to cut into walls, fish through insulation, or install extensive conduit just to get a wire to each device.

The ST-CS is a Cresnet expansion module that provides power sensing of two individual devices such as televisions, AV receivers, and many other AC powered device. A typical application for current sensing is to provide confirmation of the device's power on/off state. This is often necessary to enable reliable power control for IR controlled devices that do not include discrete power commands in their IR control protocol. The ST-CS may be used to provide a current sensing interface wherever...

The ST-CS is a Cresnet expansion module that provides power sensing of two individual devices such as televisions, AV receivers, and many other AC powered device. A typical application for current sensing is to provide confirmation of the device's power on/off state. This is often necessary to enable reliable power control for IR controlled devices that do not include discrete power commands in their IR control protocol. The ST-CS may be used to provide a current sensing interface wherever...

The CEN-RFGW-EX is a 2-way RF wireless transceiver designed for use with Crestron infiNET EX and ER (extended Range RF) wireless devices. A single CEN-RFGW-EX gateway enables an entire wireless network of Crestron remotes, keypads, lighting dimmers, motorized shades, thermostats, door locks, and other devices to communicate with a Crestron control system.