Video
Input Signal Types HDMI with HDR10, HDR10+, Dolby Vision, Deep Color, 4K60 4:4:4 support1, 2 (DVI and Dual-Mode DisplayPort™ interface compatible3)
Output Signal Types HDMI with HDR10, HDR10+, Dolby Vision, Deep Color, and 4K60 4:4:4 support1, 2 (DVI compatible4)
Switcher 8x8 digital AV switcher
Copy Protection HDCP 2.3
Maximum Resolutions Common resolutions are listed in the following table.
Scan
Type Resolution Frame
Rate Color
Sampling Color
Depth
Progressive 4096x2160 DCI 4K
and 3840x2160 4K UHD 24 Hz 4:4:4 36 bit
30 Hz 4:4:4 36 bit
60 Hz 4:2:2 36 bit
60 Hz 4:4:4 24 bit
2560x1600 WQXGA 60 Hz 4:4:4 36 bit
1920x1080 HD 1080p 60 Hz 4:4:4 36 bit
Interlaced
(Input Only) 1920x1080 HD 1080i 30 Hz 4:4:4 36 bit
NOTE: Custom resolutions that do not exceed 4096 pixels in width and 2160 pixels in height are supported at pixel clock rates up to 600 MHz.
Audio - General
Digital-To-Analog Conversion 24-bit 48 kHz
Frequency Response ±0.5 dB, 20 Hz to 20 kHz
THD+N <0.005%, 1 kHz, 10 dBV
S/N Ratio >95 dB, 10 dBV, 20 Hz to 20 KHz, A-weighted
Crosstalk ≤90 dB, 1 KHz, for multiple inputs only
Stereo Separation ≤80 dB, 20 Hz to 20 kHz
Audio - Source Inputs
Input Signal Type HDMI (Dual-Mode DisplayPort interface compatible3)
Formats Dolby Digital®, Dolby Digital EX, Dolby Digital Plus, Dolby® TrueHD, Dolby Atmos®, DTS®, DTS-ES, DTS 96/24, DTS HD® High Res, DTS-HD Master Audio, DTS:X®, LPCM up to 8 channels
Audio - Digital Output
Output Signal Type HDMI
Formats Dolby Digital, Dolby Digital EX, Dolby Digital Plus, Dolby TrueHD, Dolby Atmos, DTS, DTS-ES, DTS 96/24, DTS HD High Res, DTS-HD Master Audio, DTS:X, LPCM up to 8 channels
Source -80 dB to +20 dB adjustment range, plus Mute
Master Volume -80 dB to +20 dB adjustment range, plus Mute
Audio - Analog Line Output
Output Signal Type/Format Stereo 2-channel
Volume Control -80 dB to +20 dB adjustment range, plus Mute, Mono, and Stereo
Communications
Ethernet 100/1000 Mbps, auto-switching, auto-negotiating, auto-discovery, full/half duplex, DHCP, Web browser setup and control, Crestron control system integration, IEEE 802.1X, Secure CIP, Authentication, SSH/SSL, TLS
USB For firmware loading and configuration management and to power a USB powered device
HDMI HDCP 2.3, EDID, CEC
Connectors
HDMI IN 1-8 (8) 19-pin Type A connector, female;
HDMI digital video/audio input (DVI and Dual-Mode DisplayPort interface compatible3)
HDMI OUT 1-8 (8) 19-pin Type A connector, female;
HDMI digital video/audio output (DVI compatible4)
AUDIO OUT, AUX 1-2 (2) 5-pin 3.5 mm detachable terminal block;
Balanced/unbalanced stereo line-level audio output;
Output Impedance: <100 Ohms;
Maximum Output Level: 4 Vrms balanced, 2 Vrms unbalanced
LAN (1) 8-pin RJ-45 connector, female;
100BASE-TX/1000BASE-T Ethernet port
24VDC 2.5 A (1) 2.1 x 5.5 mm DC power connector;
24 VDC power input;
PW-2420RU power pack included
SERVICE (1) USB Type A female;
For firmware loading and configuration management;
Can also provide up to 5 V 500 mA power to a USB powered device
G (1) 6-32 screw, chassis ground lug
Controls and Indicators
PWR (1) LED. Amber indicates that the device is booting. Green indicates that the device is operational.
INPUT 1-8 (8) Push buttons for manual input selection and (8) LEDs. Green indicates that the corresponding input is routed to an output.
Amber indicates that a source is detected at the corresponding input but is not routed to an output.
OUTPUT 1-8 (8) Push buttons for manual output selection and (8) LEDs. Green indicates that a display or other destination device is detected and the corresponding output is transmitting video. Amber indicates that a display or other destination device is detected but no video is routed to the corresponding output.
SETUP (1) Red LED and (1) push button for display of IP address on connected HDMI outputs
Ethernet (2) LEDs on RJ-45 LAN connector.
Link status LED: Green indicates that a 100BASE-TX link is established. Amber indicates that a 1000BASE-T link is established.
Ethernet activity LED: Flashing amber indicates Ethernet activity.
Power
Power Pack (Included) Input: 1.3 A maximum @ 100-240 VAC, 50/60 Hz;
Output: 2.5 A @ 24 VDC;
Model: PW-2420RU
Power Consumption 29 W typical
Environmental
Temperature 32° to 104° F (0° to 40° C)
Humidity 10% to 90% RH (non-condensing)
Heat Dissipation 98 BTU/hr typical
Acoustic Noise 33.55 dBA typical
Construction
Chassis Metal, black finish, vented sides
Mounting 1 RU 19-inch rack-mountable (rack ears included)
Dimensions
Height 1.72 in. (44 mm)
Width 17.33 in. (441 mm) without rack ears
Depth 7.02 in. (179 mm)
Weight
5.15 lb (2.37 kg)