| Video |
| Switcher | 2x1 manual or auto-switching, audio-follow-video |
| Scaler | HD video scaler and deinterlacer, noise reduction, 3:2/2:2 pull-down detection and recovery, aspect ratio selection, VGA phase/clock & H/V position adjustments, picture and RGB color adjustments |
| Input Signal Types | HDMI w/Deep Color (DVI & Dual-Mode DisplayPort compatible[5]), DM Lite link |
| Output Signal Types | HDMI w/Deep Color (DVI compatible[4]) |
| Copy Protection | HDCP 1.4 |
Maximum Input Resolutions | Input Type | Scan Type | Resolution | Frame Rate |
|---|
HDMI
&
DM Lite Link | Progressive | 1920x1200 WUXGA | 60 Hz | | 1920x1080 HD 1080p | 60 Hz | | Interlaced | 1920x1080 HD 1080i | 30 Hz |
NOTE: Common resolutions are shown; other custom resolutions are supported at pixel clock rates up to 165 MHz |
| Scaler Output Resolutions, Progressive | Auto, 640x480@60Hz, 720x480@60Hz (480p), 720x576@50Hz (576p), 800x600@60Hz, 840x480@60Hz, 1024x768@60Hz, 1280x720@50/60Hz (720p50/60), 1280x768@60Hz[6], 1280x800@60Hz[6], 1280x960@60Hz, 1280x1024@60Hz, 1360x768@60Hz, 1366x768@60Hz[6], 1400x1050@60Hz[6], 1440x900@60Hz[6], 1600x900@60Hz[7], 1600x1200@60Hz, 1680x1050@60Hz[6], 1920x1080@30/50/60Hz (1080p30/50/60), 1920x1200@60Hz[7] |
| Scaler Output Resolutions, Interlaced | Auto, 480i, 576i, 1080i25, 1080i30 |
| Audio |
| Input Signal Types | HDMI (Dual-Mode DisplayPort compatible[5]), DM Lite link |
| Output Signal Types | HDMI, analog stereo[1] |
| Digital Formats | Dolby Digital, Dolby Digital EX, DTS, DTS ES, DTS 96/24, LPCM up to 8 channels |
| Analog Formats | Stereo 2-channel[1] |
| Digital-To-Analog Conversion | 24-bit 48 kHz |
| Analog Output Volume | -80 to +20 dB Level adjustment range, plus Mute |
| Analog Output Lip-Sync Delay | 0 to 150 ms (maximum delay time is reduced for input signals with sampling rates over 48 kHz) |
| Analog Performance | Frequency Response: 20 Hz to 20 kHz ±0.5 dB;
S/N Ratio: >93 dB, 20 Hz to 20 kHz A-weighted;
THD+N: <0.005% @ 1 kHz;
Stereo Separation: >80 dB |
| Communications |
| Ethernet | 10/100 Mbps, auto-switching, auto-negotiating, auto-discovery, full/half duplex, DHCP, web browser setup and control, Crestron control system integration |
| RS-232 | 2-way device control and monitoring up to 115.2k baud with hardware and software handshaking |
| IR | 1-way device control via infrared up to 60 kHz |
| HDMI | HDCP 1.4, EDID, CEC |
| DM Lite Link | Proprietary link for connection between one DM Lite RX & TX only |
| Note: Supports management of HDCP and EDID; supports management of CEC between the connected HDMI devices and a control system (inclusive of the local HDMI ports and those on the transmitter), does not support IR or RS-232 signal extension over the DM Lite link |
| Connectors |
| HDMI, INPUT 1 | (1) HDMI Type A connector, female;
HDMI digital video/audio input (DVI & Dual-Mode DisplayPort compatible[5]) |
| FROM TX, INPUT 2 | (1) 8-pin RJ45 connector, female, shielded;
Link port for connection to a DM Lite transmitter[2];
Maximum cable length: 230 ft (70 m) |
| HDMI OUTPUT | (1) HDMI Type A connector, female;
HDMI digital video/audio output (DVI compatible[4]) |
| AUDIO L/R | (1) 5-pin 3.5 mm detachable terminal block;
Balanced/unbalanced stereo line-level audio output[1];
Maximum Output Level: 4 Vrms balanced, 2 Vrms unbalanced;
Output Impedance: 200 Ohms balanced, 100 Ohms unbalanced |
| IR | (1) 2-pin 3.5 mm detachable terminal block;
IR output control port;
Supports IR up to 60 kHz;
IRP2 emitter sold separately;
Note: Provides power on/off control of the display device without a control system, or fully programmable control of any device with a control system. Does not support IR signal extension over the DM Lite link. |
| COM | (1) 5-pin 3.5 mm detachable terminal block;
Bidirectional RS-232 port;
Supports RS-232 up to 115.2k baud with hardware and software handshaking;
Note: Provides power on/off control of the display device without a control system, or fully programmable control of any device with a control system. Does not support RS-232 signal extension over the DM Lite link. |
| LAN | (1) 8-pin RJ45 connector, female;
10Base-T/100Base-TX Ethernet port |
| 24VDC 1.25A | (1) 2.1 x 5.5 mm DC power connector;
24 Volt DC power input;
PW-2412WU power pack included;
Note: This connection powers both the receiver and transmitter[3] |
| SERVICE | (1) USB Type A connector, female;
For factory use only |
| Indicators |
| FROM TX, INPUT 2 | (2) LEDs (on RJ45 connector), green LED indicates DM Lite link status, amber LED indicates a valid video signal |
| LAN | (2) LEDs (on RJ45 connector), green LED indicates Ethernet link status, amber LED indicates Ethernet activity |
| PWR | (1) Bi-color green/amber LED, indicates operating power is supplied from the power pack via the 24VDC input or from the TX via the DM Lite link, turns amber while booting and green when operating |
| AUTO | (1) Pushbutton to enable/disable auto-switching mode, and (1) green LED to indicate auto-switching mode it enabled |
| INPUT 1 – 2 | (2) Pushbuttons for manual input selection, and (2) bi-color green/amber LEDs to indicate the current active input and signal presence at each corresponding input |
| SETUP | (1) Red LED and (1) recessed pushbutton for Ethernet setup |
| Power |
| Power Pack (included) | Input: 100-240 Volts AC, 50/60 Hz;
Output: 1.25 Amps @ 24 Volts DC;
Model: PW-2412WU |
| Note: The receiver and transmitter are powered together using a single power pack connected at either the receiver or transmitter (not both).[3] |
| Environmental |
| Temperature | 32° to 104° F (0° to 40° C) |
| Humidity | 20% to 90% RH (non-condensing) |
| Construction |
| Chassis | Metal, black finish, with (2) integral mounting flanges, vented sides |
| Mounting | Freestanding, surface mount, or attach to a single rack rail |
| Dimensions |
| Height | 1.11 in (28 mm) |
| Width | 7.70 in (196 mm) |
| Depth | 4.94 in (126 mm) |
| Weight |
| 20.82 oz (590 g) |
| Compliance |
| UL Listed for US & Canada, CE, IC, FCC Part 15 Class B digital device |