Crestron

The CLTIBN circuit breaker terminal blocks are designed to install in CAENIB automation enclosures to provide load-side circuit breakers, and facilitate the termination of high-voltage wiring for each CLXI-Series lighting control module. The color-coded DIN rail design, complete with printed label strips and mounting hardware, provides for a clean and simple installation. Each CLTIBN model includes a front escutcheon panel and hinged door assembly, and weighs approximately 1.82 kg (4.0 lb).

The CLWI-SWEX-delivers native Crestron control to any light or other switched load in new or retrofit 230 Volt applications. Featuring reliable infiNET EX wireless technology, the CLWI-SWEX-can be installed in virtually any location thanks to reliable mesh networking. Support for up to 2 Amp loads makes this switch perfect for most applications.

The CLWI-SWEX-delivers native Crestron control to any light or other switched load in new or retrofit 230 Volt applications. Featuring reliable infiNET EX wireless technology, the CLWI-SWEX-can be installed in virtually any location thanks to reliable mesh networking. Support for up to 2 Amp loads makes this switch perfect for most applications.

The C2N-SDC is a 2-channel Shade and Drape Controller designed to provide a convenient and cost-effective solution for controlling a variety of motorized window treatments as well as motorized doors, sunroofs, lifts and projection screens. The C2N-SDC is a Cresnet device with two independently controlled 120V AC outputs. Each output provides up/down or open/close control of a conventional three-wire bidirectional type motor. Built-in timing and interlock logic make it easy to program the...

The C2N-SDC-DC is a 2-channel Shade and Drape Controller designed to provide a convenient and cost-effective solution for controlling 24 Volt DC motorized shades and drapes. The C2N-SDC-DC is a Cresnet device with two independently controlled 24V DC outputs, each designed to provide standard up/down or open/close control of a conventional two-wire bidirectional type motor.

The C2N-SSC-2 Somfy Shade Controller is a compact Cresnet device designed to provide a bidirectional serial interface for up to two Somfy ILT[1] Intelligent Shade Motors. Window treatments equipped with the Somfy ILT motor offer enhanced capability compared to typical three-wire models.

CAEN-CK Cover Kits are designed to extend the depth of Crestron's CAEN and CAENIB Automation Enclosures, affording 1.5 inch (3.81 cm) additional depth to accommodate EX ess wiring and third-party devices.

The CLXI-4IND inductor module provides noise suppression for up to 4 dimmed loads. Each channel inserts a high-inductance filter choke inline between any channel of a CLXI-Series dimmer module and its load. The CLXI-4IND occupies a single module space in a CAEN or CAENIB automation enclosure. Termination of high-voltage wiring to the module is facilitated by either a CLTI-4IND terminal block or CLTIBN-4IND circuit breaker terminal block, each sold separately to enable termination of the wiring...

The C2N-MNETGW is a 2-way RF gateway/transceiver designed to enable communications and management for a complete infiNET wireless network of dimmers, keypads, and other devices. The C2N-MNETGW links the infiNET network to a Crestron control system via Cresnet.

CAEN-CK Cover Kits are designed to extend the depth of Crestron's CAEN and CAENIB Automation Enclosures, affording 1.5 inch (3.81 cm) additional depth to accommodate EX ess wiring and third-party devices.