Crestron

The CNTBLOCK is a parallel distribution block designed to facilitate the termination of multiple Cresnet cables in an equipment cabinet, closet, or beneath a table. Eight 4-pin connectors are provided, grouped in two sets of four. Power can be isolated between the two sets by removing an internal jumper. Diagnostic LEDs indicate the presence of network power and data. The CNTBLOCK includes integral mounting flanges to allow for attachment to any suitable flat surface.

The ST-CNB is a parallel distribution block and converter designed for termination of multiple Cresnet cables, and adapting between several 4-wire Cresnet cables and modular type Cresnet cables. Two 4-pin Cresnet connectors and four 6-pin RJ11 jacks are provided, all wired in parallel

The CNCS provides power sensing of any single AC powered device or AC load up to 5 Amps. A current sensor is typically used with any television, AV receiver, etc. to provide confirmation of the device's power on/off state. This is often necessary to enable reliable power control for IR controlled devices that do not include discrete power commands in their IR control protocol.

This is the replacement internal battery pack for the CEN-UPS1250 Uninterruptible Power Supply.

The C2N-IO is a very compact device that adds control ports to any Crestron2-Series or 3-Series control system. It connects via the Cresnet control network and provides one RS-232, one IR, and two relay control ports. It can be mounted to any flat surface using two screws or adhesive reclosable fastener (3M Dual Lock included).

The ST-PC is a Cresnet expansion module that provides switching of AC power to two individual loads for on/off control of video monitors, tape decks, small audio amplifiers, and other AC powered devices. The ST-PC may be used to provide a power control interface wherever required for loads up to 1200 Watts, and may be rack-mounted using the optional ST-RMK rack mount kit (sold separately). Communication with the control system is via a single Cresnet connection.

The ST-PC is a Cresnet expansion module that provides switching of AC power to two individual loads for on/off control of video monitors, tape decks, small audio amplifiers, and other AC powered devices. The ST-PC may be used to provide a power control interface wherever required for loads up to 1200 Watts, and may be rack-mounted using the optional ST-RMK rack mount kit (sold separately). Communication with the control system is via a single Cresnet connection.

The CEN-SW-POE-5 is a 5-port unmanaged Gigabit Ethernet switch that provides Power over Ethernet (Poe) from four of its ports. Power over Ethernet affords a one-wire solution for connecting Crestron touch screens, gateways, and other devices, delivering power and data over a single CAT5/6 network cable. All 5 ports are Gigabit capable to ensure maximum bandwidth for multimedia and critical control data.Using the CEN-SW-POE-5, there is no need to install a separate power supply at each...

Activates the Modular Programming Architecture feature of the RMC3 3-Series Room Media Controller. Enables support for running up to 10 simultaneous programs on a single RMC3.

The C2N-IRGW-1G IR Gateway is a 1-way infrared receiver for Crestron iR wireless handheld remotes and touch panels. It is also compatible with third-party IR remotes utilizing the RC5 command set.